大联大品佳集团推出基于NXP和Microchip的PIC18F25K20多通道汽车大灯解决方案
原标题:大联大品佳集团推出基于NXP和Microchip产品的多通道汽车大灯解决方案
2016年8月9日,致力于亚太地区市场的领先半导体元器件分销商---大联大控股宣布,其旗下品佳集团推出基于恩智浦(NXP)ASL3315、ASL4500和Microchip PIC18F25K8-E/SS的多通道汽车大灯解决方案。
图示1-大联大品佳推出的基于NXP和Microchip产品的多通道汽车大灯解决方案系统框架图
相似料号:
PIC18F25K20
Features:
C Compiler Optimized Architecture:
Optional extended instruction set designed to optimize re-entrant code
Up to 1024 bytes Data EEPROM
Up to 64 Kbytes Linear program memory addressing
Up to 3936 bytes Linear data memory addressing
Up to 16 MIPS operation
High Performance RISC CPU:
C Compiler Optimized Architecture:
Optional extended instruction set designed to optimize re-entrant code
Up to 1024 bytes Data EEPROM
Up to 64 Kbytes Linear program memory addressing
Up to 3936 bytes Linear data memory addressing
Up to 16 MIPS operation
16-bit wide instructions, 8-bit wide data path
Priority levels for interrupts
31-level, software accessible hardware stack
8 x 8 single-cycle hardware multiplier
Flexible Oscillator Structure:
Precision 16 MHz internal oscillator block:
Factory calibrated to ± 1%
Software selectable frequencies range of 31 kHz to 16 MHz
64 MHz performance available using PLL
no external components required
Four crystal modes up to 64 MHz
Two external clock modes up to 64 MHz
4X Phase Lock Loop (PLL)
Secondary oscillator using Timer1 @ 32 kHz
Fail-Safe Clock Monitor:
Allows for safe shutdown if peripheral clock
stops
Two-Speed Oscillator Start-up
Special Microcontroller Features:
Operating Voltage Range: 1.8V to 3.6V
Self-Programmable under Software Control
Programmable 16-Level High/Low-Voltage
Detection (HLVD) module:
Interrupt on High/Low-Voltage Detection
Programmable Brown-out Reset (BOR):
With software enable option]
Extended Watchdog Timer (WDT):
Programmable period from 4 ms to 131s
Single-Supply 3V In-Circuit Serial Programming™ (ICSP™) via two pins
In-Circuit Debug (ICD) via Two Pins
Extreme Low-Power Management with nanoWatt XLP™:
Sleep mode: 100 nA
Watchdog Timer: 500 nA
Timer1 Oscillator: 500 nA @ 32 kHz
Analog Features:
Analog-to-Digital Converter (ADC) module :
10-bit resolution, 13 External Channels
Auto-acquisition capability
Conversion available during Sleep
1.2V Fixed Voltage Reference (FVR) channel
Independent input multiplexing
Analog Comparator module:
Two rail-to-rail analog comparators
Independent input multiplexing
Voltage Reference (CVREF) module
Programmable (% VDD), 16 steps
Two 16-level voltage ranges using VREF pin
Peripheral Highlights:
Up to 35 I/O pins plus 1 input-only pin:
High-Current Sink/Source 25 mA/25 mA
Three programmable external interrupts
Four programmable interrupt-on-change
Eight programmable weak pull-ups
Programmable slew rate
Capture/Compare/PWM (CCP) module
Enhanced CCP (ECCP) module:
One, two or four PWM outputs
Selectable polarity
Programmable dead time
Auto-Shutdown and Auto-Restart
Master Synchronous Serial Port (MSSP) module
3-wire SPI (supports all 4 modes)
I2C™ Master and Slave modes with address mask
Enhanced Universal Synchronous Asynchronous Receiver Transmitter (EUSART) module:
Supports RS-485, RS-232 and LIN
RS-232 operation using internal oscillator
Auto-Wake-up on Break
Auto-Baud Detect
随着LED发光二极的效能越来越高,寿命越来越长,LED技术的进步,让LED光源进入了汽车照明领域。除了刹车灯,日间行车灯外,汽车大灯也越来越多的使用LED产品,并且对产品结构尺寸、性价比、智能化等提出了更高的要求。大联大品佳为响应市场需要,推出了NXP + Microchip的多通道汽车大灯方案。
图示2-大联大品佳推出的基于NXP和Microchip产品的多通道汽车大灯解决方案开发板照片
大联大品佳的该多通道汽车大灯方案是为汽车灯光模块量身定做的解决方案,该方案包含3路输出。ASL4500把电池电压升到一个或两个稳定的电压值,作为功率母线负载使用。ASL3415则是有3路独立输出的降压恒流控制芯片,每路均可输出最大1.5A电流以驱动LED。所有参数的设定都是通过Microchip高性能汽车级MCU PIC18F25K8-E/SS使用SPI通讯方式进行控制,同时负责使用PWM调光与汽车通讯功能。
责任编辑:HanFeng
【免责声明】
1、本文内容、数据、图表等来源于网络引用或其他公开资料,版权归属原作者、原发表出处。若版权所有方对本文的引用持有异议,请联系拍明芯城(marketing@iczoom.com),本方将及时处理。
2、本文的引用仅供读者交流学习使用,不涉及商业目的。
3、本文内容仅代表作者观点,拍明芯城不对内容的准确性、可靠性或完整性提供明示或暗示的保证。读者阅读本文后做出的决定或行为,是基于自主意愿和独立判断做出的,请读者明确相关结果。
4、如需转载本方拥有版权的文章,请联系拍明芯城(marketing@iczoom.com)注明“转载原因”。未经允许私自转载拍明芯城将保留追究其法律责任的权利。
拍明芯城拥有对此声明的最终解释权。